|
|
|
check partition |
| |
does a simple check on partition.
|
|
cp [source-device] source dest |
| |
copies the source partition’s filesystem on source-device (or the
current device if no other device was specified) to the dest partition
on the current device.
|
|
help [command] |
| |
prints general help, or help on command if specified.
|
|
mkfs partition fs-type |
| |
make a filesystem fs-type on partition. fs-type can be one
of "fat16", "fat32", "ext2", "linux-swap" or "reiserfs".
|
|
mklabel label-type |
| |
Creates a new disklabel (partition table) of label-type.
label-type should be one of "bsd", "dvh", "gpt", "loop", "mac", "msdos",
"pc98" or "sun".
|
|
mkpart part-type [fs-type] start end |
| |
make a part-type partition with filesystem fs-type (if specified),
beginning at start and ending at end (in megabytes).
fs-type can be one of
"fat16", "fat32", "ext2", "HFS", "linux-swap", "NTFS", "reiserfs" or "ufs".
part-type should be one of "primary", "logical" or "extended"
|
|
mkpartfs part-type fs-type start end |
| |
make a part-type partition with filesystem fs-type beginning at
start and ending at end (in megabytes)
|
|
move partition start end |
| |
move partition to start at start and end at end. Note: move
never changes the minor number
|
|
name partition name |
| |
set the name of partition to name. This option works only on Mac
and PC98 disklabels. The name can be placed in quotes, if necessary
|
|
print |
displays the partition table
|
|
quit |
exits parted
|
|
resize partition start end |
| |
resize the filesystem on partition to start at start and end at
end megabytes
|
|
rm partition |
| |
deletes partition
|
|
select device |
| |
choose device as the current device to edit. device should usually
be a Linux hard disk device, but it can be a partition, software raid device or
a LVM logical volume if that is necessary
|
|
set partition flag state |
| |
change the state of the flag on partition to state. Flags
supported are: "boot", "root", "swap", "hidden", "raid", "lvm", "lba" and
"palo".
state should be either "on" or "off"
|
|