---

Manual Reference Pages  - I2CDETECT (8)

---

i2cdetect - detect I2C chips

CONTENTS

Synopsis
Description
Warning
Options
Conforming To
See Also
Author

i2cdetect [-y] [-a] [-q|-r] i2cbus
i2cdetect -V
i2cdetect -l

i2cdetect is a userspace program to scan an I2C bus for devices. It outputs a table with the list of detected devices on the specified bus. i2cbus indicates the number of the I2C bus to be scanned, and should correspond to one of the busses listed by i2cdetect -l.

This program can confuse your I2C bus, cause data loss and worse!

-y	Disable interactive mode. By default, i2cdetect will wait for a confirmation from the user before messing with the I2C bus. When this flag is used, it will perform the operation directly. This is mainly meant to be used in scripts.
-a	Force scanning of non-regular addresses. Not recommended.
-q	Use SMBus "quick write" commands for probing (by default, the command used is the one believed to be the safest for each address). Not recommended. This is known to corrupt the Atmel AT24RF08 EEPROM found on many IBM Thinkpad laptops.
-r	Use SMBus "read byte" commands for probing (by default, the command used is the one believed to be the safest for each address). Not recommended. This is known to lock SMBus on various write-only chips (most notably clock chips at address 0x69).
-V	Display the version and exit.
-l	Output a list of installed busses.

lm_sensors-2.x

i2cdump(8), sensors-detect(8)

Frodo Looijaard, Mark D. Studebaker, and the lm_sensors group http://www.lm-sensors.nu/ This manual page was written by Aurelien Jarno <aurel32@debian.org>, for the Debian GNU/Linux system. It was then reviewed by the lm_sensors team and is now part of the lm_sensors source distribution.

Jump to page    or go to Top of page |  Section 8 |  Main Index.